Bearing Designs
Selection, replacement and quotation support
Plate-mounted combined bearings reduce fabrication steps and can be supplied for AP-series or drawing-based assemblies.
Plate configurations
The bearing, weld location, plate thickness, holes and datum geometry form one controlled assembly.
- AP0, AP1, AP2 and AP3.1
- Lubricated and Q variants
- Custom laser-cut or machined plates
Drawing requirements
Plate assemblies should be quoted from an approved drawing rather than bearing designation alone.
- Hole pattern and tolerances
- Weld specification and distortion control
- Coating and corrosion protection
Recommended next steps
Welded Plate Combined Bearings FAQ
How do I specify combined bearings welded on plate?
Send the complete model, all suffixes, quantity, delivery country and a controlled drawing when available. Also state load, speed, environment and mounting details.
Can you verify an equivalent combined bearings welded on plate?
Yes. Cross-reference numbers start the review, but interchangeability is confirmed from dimensions, internal design, adjustment, load capacity, lubrication and operating conditions.
What information is required for a quotation?
Provide the old marking, photos or drawing, critical dimensions, application, quantity and destination. Required inspection documents should be stated before quotation.